How to Prolong Service Life of Lights and Maintain Lighting
May 3, 2011 Category :Lighting Wiki 0
Experts advise not to use lights to make frequent switches, as often start in the moment of lighting, the current through the filament is greater than the current normal working hours, making the filament temperature increases dramatically accelerate sublimation, which will greatly reduce its service life Therefore, to minimize the lamp switch.
The safe use of lamps, and extend the life of the lamp? The Council reminded the experts in Fujian Province, in the use of lighting, we should note the following.
First of all, buy lamps, first do not just install the lamp should be carefully read and read the installation manual marking in accordance with the provisions of the instructions to install, use lamps, or they may be dangerous.
Next, click the logo to provide timely replacement of aging light source parameters of the lamp, both ends of that red lamp, lamp black or dark shadows, jump off the lamp, the lamp should be replaced, prevent ballast burn and other insecurity.
Again, in the cleaning and maintenance should be careful not to change the lighting of the structure, and do not easily replace the lamp parts, after the end of the cleaning and maintenance, as is the lighting should be installed, not to leave, the wrong lighting components installed.
Finally, the lamps in use must also strengthen the maintenance, to prolong its life. To note the following specific points: the room lamp should always wipe with a dry cloth, and to guard against moisture intrusion, a long time in order to avoid corrosion damage or leakage occurs the phenomenon of short circuit; installed in the toilet, bathroom lights shall be fitted with damp shade, otherwise it will greatly reduce the service life; installed the lights in the kitchen, special attention should be anti-smoke, because the accumulation of grease will affect the light illumination; a light shade of light transmission is good, but easy to stick ash, should wash the cleaning, so as not to affect the light penetration; lamps if non-metallic, can be used wet wipe, to prevent dust accumulation, prevent lighting effects.

































